Yes, The Can Kat's Heaters Oil or Transmission Pan Heating Pad # KH24150 is intended to be left plugged in overnight, which will make your cold-weather morning starts a lot easier. As a note the cartridge heater should not be used with 100 percent antifreeze solutions, and the engine should not be started with the heater still plugged in.
If you have any further questions please feel free to reach back out to me anytime and I will be more than happy to further assist you in your towing... view full answer...
The Kat's Heaters magnetic heater that you would use on your 2008 Chevy truck is the Handi-Heat Magnum # KH1190. It's designed to heat an area up to 20 square inches and is made for larger trucks. It does include a thermostat to automatically shut off when it reaches 275 degrees Farhrenheit.
275 degrees does sound extremely hot. However, since the heater has to compete with external temperatures (Which are going to be quite cold or the heater wouldn't be necessary) plus transfer heat... view full answer...
Sounds like you're looking for the Kat's Heaters Custom Engine Block Heater # KH11484 for your 2019 Chevy Equinox. This replaces your frost plug in the engine block and submerges in the coolant to help keep your engine warm. It also has a plug for AC power that you can secure inside your engine compartment and plug in at night.
From what I could find it looks like the frost plug will be located on the corner of the lower grille on the driver's side. view full answer...
I may have a solution for you, but yes- the ThermaHeat RV Holding Tank Heaters # 277-000164 are designed for more standard tanks that are made from hard plastic. However, you might be able to use something like the Kat's Heaters Oil or Transmission Pan Heating Pad - 5-1/2" x 8-1/2" - 120V - 500 Watts # KH24500, which is be used on 7-10 gallon water tanks. This is the largest tank heater available that would likely work, but you may be able to use more than 1 to help keep your stainless... view full answer...
It sounds like you're going to need a hitch, wiring, ball mount and hitch ball, 7 way plug and brake controller, and we do have all of those parts you're looking for. To start, for a hitch I recommend using the Curt # C13146 you were looking at since Curt hitches have a durable powder coating that will help ensure that the hitch holds up over time.
For wiring, I recommend using the Tekonsha # 118286 since it's the easiest to install wiring harness. This is a plug and play installation,... view full answer...
Go To Results